TFTM-EGPR: Engineering Print Review

Trinity Forge Training Module
TFTM-EGPR: Engineering Print Review

REV: 08/23/07

Taught by: VP Quality & Engineering, Forging Engineer

Objective: To focus on the critical nature of forging prints, primarily, but not limited to stamping and customer specified critical dimensions. Also standardization and review of same.

Syllabus: One session explaining print notes and customer specified critical dimensions.

	Stress the important role of the engineers to production relative to prints.
	Understanding of basic stamping/marking principles and terminology.
	The need to state method of stamping, location of stamping, the correct size of stamping and required stamping.
	Review of prints created by fellow engineers.
	Communicating critical dimensions to person responsible for entering data in SPC.

Completion: Sign off by teacher that employee has been instructed and has a good understanding of the print stamping and review.

Notes:

Go to Team Positions (TFTP) | Go to Training Modules (TFTM)
Go to Trinity Operating Procedures (TOPs) | Go to Trinity Forge Home

See an uncontrolled translation of this page in the language of your choice:

Search this web site or the entire web:

Documents are controlled only when viewed on-line in the original English -- printed copies or translations are not controlled documents

REV: 08/23/07

© 2008 Trinity Forge, Inc., +1 817-473-1515