TFTM-HCOM:How to Clock In and Clock Out in M2M

Trinity Forge Training Module
TFTM-HCOM:How to Clock In and Clock Out in M2M

REV: 12/05/2006

Taught by: Steelyard Supervisor, Steelyard Leadman

Objective: To instruct the steelyard employees in the basic procedure of clocking in and out of the M2M system.

	How to make an entry for machine setups
	How to make an entry for a quantity of cut material and for a quantity of scrapped material
	How to enter information for a stud welding procedure
	How to scan out when unloading a truck

Syllabus:

Session will cover the procedure for steelyard entries in M2M explaining the importance of entering the correct information when making a M2M entry.

Completion: Each employee will sign off on the Training Record Sheet acknowledging that they have been instructed in how to clock in, clock out and make correct entries in M2M.

Notes: All attendees must give correctly a detailed example of a M2M entry.

Go to Team Positions (TFTP) | Go to Training Modules (TFTM)
Go to Trinity Operating Procedures (TOPs) | Go to Trinity Forge Home

See an uncontrolled translation of this page in the language of your choice:

Search this web site or the entire web:

Documents are controlled only when viewed on-line in the original English -- printed copies or translations are not controlled documents

REV: 12/05/2006

© 2008 Trinity Forge, Inc., +1 817-473-1515