TFTM-PRCP: Print Change Procedure

Trinity Forge Training Module
TFTM-PRCP: Print Change Procedure

REV: 04/14/206

Taught by: Quality Control Manager or Supervisor

Objective: To instruct designated employee on how to make necessary changes to blueprints.

Syllabus: Session on Print Change Procedures

If any employee sees a necessary change on a blueprint

Take print to supervisor for markup

Supervisor will hand carry marked up print to Engineering

Engineering will initial marked up print for approval

Engineering will make necessary changes to bring print current

During Production (after hours)

	Supervisor will mark and initial prints (production continues)
	Hand carry to Engineering for next day approval. (follow up with e-mail)

Completion: Sign off by teacher that employee has been instructed and has a good understanding of the Print Change Procedure

Note: Mark ups (changes) must have Engineering/Supervisor approval.

Go to Team Positions (TFTP) | Go to Training Modules (TFTM)
Go to Trinity Operating Procedures (TOPs) | Go to Trinity Forge Home

See an uncontrolled translation of this page in the language of your choice:

Search this web site or the entire web:

Documents are controlled only when viewed on-line in the original English -- printed copies or translations are not controlled documents

REV: 04/14/206

© 2008 Trinity Forge, Inc., +1 817-473-1515